AAArc and Axis Notes
Issue 20  welding stations · arc to axis2026-11-20
Issue 20 · eight stations

The arc is a number.

Arc and Axis Notes follows a weldment through the station: the transfer mode, the clamp sequence, the track under the robot, the positioner's centre of gravity, the mark, the kerf, the belt and the fixture.

NotesEight
Sections10 each
Checks64
Filed2026-11-20

Index

No. 01 – 08
NO 01

MIG/MAG on a robot: the transfer mode is the parameter, not the wire feed number

Two welders with the same wire feed and the same voltage can run different transfer modes, and only one of them is stable at the joint in front of the robot.

Arc
NO 02

Longitudinal seam welding: the clamp sequence decides the seam before the laser does

A longitudinal seam is two edges held together for a metre. The distortion that ruins it is set by the clamping order, not by the weld parameters.

Seam
NO 03

Floor tracks: the robot's accuracy is decided by the slab under it

A seventh-axis track extends a robot's reach by metres. The straightness of the rail, not the robot's repeatability, sets the accuracy at the far end.

Track
NO 04

U-type positioners: the second axis is a balance problem before it is a motion problem

A two-axis U positioner holds a weldment at a centre of gravity it does not know. The torque at the trunnion is set by the part, not by the payload rating.

Axis
NO 05

Laser marking: contrast is a surface condition, and it changes with the alloy

Two marks specified as the same grey can differ by a factor in legibility, because annealed marking depends on the oxide and engraved marking depends on the depth.

Mark
NO 06

Laser cutting: the kerf is a pressure problem as much as a power problem

A cut that is drossy at the bottom and clean at the top is usually a gas problem, and the gas problem is usually the nozzle, not the pressure setting.

Cut
NO 07

Robotic grinding: the force is the process, and the belt is the variable

A grinding robot that holds a position instead of a force is a robot that produces a different part every twenty minutes, because the belt wears.

Grind
NO 08

Custom fixtures: repeatability is a stiffness figure before it is an accuracy figure

A fixture that locates a part to 0.05 mm and deflects 0.3 mm under the clamp is a fixture with a 0.3 mm repeatability, and the drawing will not say so.

Fixture